Product information sheet: Download PDF

How to install curtains for coach windowsUsing the simple guide below, we'll show you how to quickly and easily install the supplied curtains to your co coaches for maximum results, all you'll need is some glue and a craft knife! Step one: Unclip the body via four clips, two located on each side just next to the bogies. Their location is indicated in the following two photos.Step two: Find the plastic sheet with printed curtains from inside the carriage box. Then cut the curtains out of the acetate sheet using a craft knife or scissors, cutting down the black lines on each side of the curtains. Step three: Once you have prepared the curtains, test fit before adding the glue to make sure they fit where you'd like to position them. Once happy spread a thin line of PVA or similar glue along the edges.Step four: Place the curtain section over the desired window and firmly press and hold with a finger. After a few seconds, the glue should be tacky enough to hold the curtain in place. Step five: Turn the body over and check that the curtains are straight with no glue is visible on the window. Fit the curtains to one side of the coach and allow to dry. Apply the other side and allow to dry. Once happy, let the glue dry overnight before reassembly. Once both sides are fully dry you can clip the body back in place and enjoy.

Product information sheet: Download PDF

Fitting destination displaysYour Accurascale Mk.5 Caledonian Sleepers include a choice of two bodyside destination panels. These can be found in the small plastic bags in the packaging of the models. For fitment, we recommend a basic hobby PVA glue. To allow fitment, you'll need a small amount of PVA glue, a toothpick and a set of blunt nose tweezers.Using the toothpick, apply several small blobs of glue on the inner lip of the coach bodyside. You do not need much; four to six blobs should be more than enough.Whilst the glue is still wet, carefully fit the destination board. We suggest fitting one end first (whilst holding the other with tweezers) and then carefully 'hinging' the item into place. Allow to dry and repeat on the other side.

Removing the bodyWe don't generally recommend removing the bodies, but if you need to do so for passenger fitting or detailing, here is the location of the retaining clips. We recommend gently prying the side of the coach with a guitar pick, credit card, or similar, and sliding a card into the clip location in each spot, and the body will cleanly slide away.

Product information sheet: Download PDF

Product information sheets: Siphon G 0.33 - Download PDFSiphon G 0.44 - Download PDFSiphon G 0.59 - Download PDFSiphon G 0.62a - Download PDFSiphon G 0.62b - Download PDFSiphon G 0.62 rebuilt - Download PDFSiphon G Ambulance - Download PDF